Atlassian uses cookies to improve your browsing experience, perform analytics and research, and conduct advertising. Accept all cookies to indicate that you agree to our use of cookies on your device. Atlassian cookies and tracking notice, (opens new window)
VirtaMove Knowledge Center
VirtaMove Documentation
  • VirtaMove Support Knowledge Base
    VirtaMove Support Knowledge Base
     This trigger is hidden
Results will update as you type.
  • V-Migrate Documentation
  • V-Maestro Documentation
    • 01. Installation Guide
    • 02. Source Agents Guide
      • About Source Agents
      • Using Light Weight Monitoring
      • Installing Source Agents Manually
      • Installing Source Agents Remotely Using V-Maestro
      • Uninstalling a Source Agent
      • Troubleshooting Installing Source Agents
      • Troubleshooting the Connection to a Source
    • 03. Discovery Guide
    • 04. Managing Sources Guide
    • 05. Working with Unknown Endpoints
    • 06. Managing Destinations Guide
    • 07. Monitoring Sources Guide
    • 08. Migration Guide
    • 09. Reports Guide
    • 10. Managing V-Maestro Settings Guide
    • About VirtaMove V-Maestro Documentation
  • VirtaLinux Documentation
    You‘re viewing this with anonymous access, so some content might be blocked.
    /
    Installing Source Agents Manually
    Updated Mar 30, 2022

      Installing Source Agents Manually

      Use the procedure in this section if you want to manually install a VirtaMove Source Agent on each source server.

      If you have a large number of servers on which you want to install Source Agents, VirtaMove recommends using V-Maestro to install Source Agents remotely. To install Source Agents remotely using the V-Maestro interface, see Installing Source Agents Remotely Using V-MaestroPreview.

      Pre-Requisites

      • Ports TCP 137, 139, and 445 must be open to install VirtaMove Source Agent.

      • Port 9665 must be open to connect to the VirtaMove Source Agent on the source machine.

      Note:
      You can verify the integrity of your downloaded software by checking the MD5. See here for more details.

      To Install a Source Agent Manually

      1. On the machine where you want to install a Source Agent, run one of the following installers:

        • VirtaMoveSourceAgent_x86.msi (for 32-bit servers)

        • VirtaMoveSourceAgent_x64.msi (for 64-bit servers)

      2. The installer opens. Accept the license agreement.

      3. Select a key. See About SSL KeysPreview for more information.

      4. Repeat this procedure for each server where you want to install a Source Agent.

      {"serverDuration": 11, "requestCorrelationId": "26780142766c4aa5b0c93be4a0f085cd"}